So my clear corners came in from Jegs on Saturday. That is pretty impressive seeing as I had just ordered them on Thursday and did not pay for any kind of special shipping. The box came with both clear corners (left and right) as well as all four yellow bulbs so I can stay legal.

The installation was super easy and the only tools I needed were a phillips head screw driver and a pair of channel locks.

Start off by turning the wheel towards the opposite side of the car then the one you are working on. The first thing you do is obviously remove the bulbs. There are two bulbs in each corner (as marked in the picture below). To remove them, simply twist them counter clockwise and let them hang while you remove the lens.

The easiest way to remove the lens is by taking off the three screws in the mud well so it will open up a couple inches. To get the lens to pop out, pinch and squeeze the prongs (see below) while gently pushing in on the light from the outside of the car. The lens should pop out with little trouble.

To install the clear corners, just reverse the process. It is a tight fit so you may need to wrestle with the new part intil you get it right. When you get it in properly, you will know it. It will take no effort to get it over the white prongs. The trick is getting the inner tab to go in just right.

Now that you have your clear corners installed in your mustang, you need to go out for a joy ride. I absolutely love the clean look that the clear corners give the mustang front end, especially on a black Roush with those extra fog lights.

I love knocking off another mod from the laundry list!

This entry was posted on Tuesday, March 18th, 2008 at 9:43 pm and is filed under Mustang. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.